Yamaha RCX40, Руководство пользователя

Страница: 99 / 388

4-
39
4
Operation
9. “AUTO” mode
2. When auxiliary axis is specified:
[Procedure]
1) Press the
F 1
key in “AUTO>POINT” mode to display a screen like that shown
below, then press the
F 2
(ARCH) key.
Fig. 4-9-21 Point trace screen in ARCH motion mode (with auxiliary axis)
AUTO >POINT [RIGHTY] 50 /100% [MG][S0H0J]
————————————x———————y———————z———————r———
P3 = 150.50 64.53 21.78 -45.14
P4 = 96.65 -224.89 43.31 28.79
P5 = -63432 19735 6243 22642
COMNT : [LEFTY]
[POS] 0 0 0 0
PTP ARCH LINEAR
2) Press the
F 6
(A.AXIS+) or
F 7
(A.AXIS -) to select the axis to move by arch
motion.
The selected axis is indicated on the message line, for example “ARCH(z)” as shown
below.
Fig. 4-9-22 Point trace screen in ARCH motion mode (with auxiliary axis)
AUTO >POINT [RIGHTY] 50 /100% [MG][S0H0J]
————————————x———————y——ARCH(z)——————r———
P3 = 150.50 64.53 21.78 -45.14
P4 = 96.65 -224.89 43.31 28.79
P5 = -63432 19735 6243 22642
COMNT : [LEFTY]
[POS] 0 0 0 0
ARCH A.POS JUMP VEL+ VEL-
3) Press the
F 2
(A.POS) key and set the arch motion position.
Fig. 4-9-23 Point trace screen in ARCH motion mode (with auxiliary axis)
AUTO >POINT [RIGHTY] 50 /100% [MG][S0H0J]
————————————x———————y———————z———————r———
P3 = 150.50 64.53 21.78 -45.14
P4 = 96.65 -224.89 43.31 28.79
P5 = -63432 19735 6243 22642
COMNT : [LEFTY]
[POS] 0 0 0 0
Enter ARCH data> 20000
4) Use the cursor (
↑
/
↓
) keys and
F 14
(AXIS
←
) or
F 15
(AXIS
→
) key so that the
point value of the robot axis to be checked is highlighted.
5) Press the
START
key to move the robot by arch motion to the specified point position.
(The auxiliary axis moves by PTP.) The trace speed is one tenth of the automatic
movement speed. If the SCARA robot is selected and the hand system flag is set for
the point data, this hand system will have a priority. To stop the trace, press the
STOP
key.
w
WARNING
Upon pressing the
START
key, the
robot starts to move. To avoid
danger, do not enter the robot
movement range.
n
NOTE
If the SCARA robot is selected and the
hand system flag is set for the point
data, this hand system will have a
priority over the current arm type.