Xerox WORKCENTRE 5755, Руководство системного администратора

Страница: 45 / 356

General Setup
Xerox WorkCentre 5735/5740/5745/5755/5765/5775/5790
System Administrator Guide
37
When a user attempts to scan more pages than the Scan Job Memory Notification setting, the device
will display a message to show how many pages can be scanned before the device will slow down or be
forced to cancel the job. The default is 30 scanned pages.
To Set up the Local UI Alert
Note: To configure this feature or these settings access the Properties tab as a System
Administrator. For details, refer to Access Internet Services as System Administrator on page 16.
1. From the Properties tab, click on the [General Setup] link.
2. Click on the [Alert Notification] link.
3. Select [Local UI Alerts] in the directory tree.
4. In the Scan Disk Memory Warning area, select one of the following options to display a warning
when it is estimated that the scan disk cannot hold more than:
• 10 scanned pages .
• 30 scanned pages .
• Custom - when selected, enter an amount between 0 - 75 in the [Custom] field.
Note: The higher the page number, the more frequent the warnings will appear.
5. Click on the [Apply] button to accept the changes or [Undo] to return the settings to their
previous values.
6. Click on the [OK] button when you see the message “Properties have been successfully
modified” .
Billing Information and Usage Counters
The Billing and Counters page provides the Billing information for the device, including number of
impressions printed or copied.
1. At your Workstation, open the web browser and enter the IP Address of the device in the Address
bar, and press
<Enter> .
2. Click on the [Status] tab.
3. Select [Billing Information] in the directory tree to view Current Billing information. Click on the
[Refresh] button to refresh the Billing information.
4. Select [Usage Counters] in the directory tree to view the counts from the Usage Counters. Click on
the [Refresh] button to refresh the Usage Counters.
Energy Saver
This feature allows you to set the device to save energy when not in use. This feature is set at the
device.
Note: To configure this feature or these settings access the Tools pathway as a System
Administrator. For details, refer to Access Tools Pathway as a System Administrator on page 10.
At the Device:
1. From the Tools pathway, touch [Device Settings] .
2. Touch [General] .