XCMG XE17U, Инструкция по эксплуатации

Страница: 47 / 208

09.2020 Seite 37 / 197
3.3 Pre-inspections and Safety
Warning! Never start the engine/touch any part of the machine:
1. during maintenance/service by other personnel or
2. when a warning sign is hung on the joystick control
In the last case, wait for the warning sign to be removed by
the placer before operating the machine again.
Inspection prior to engine start
Notice The following checkups must be carried out before starting the engine:
– Remove all obstacles in the area before starting the inspection.
– Keep people away from the machine during the inspection.
– Before entering the cabin, check around the vehicle for oil leaks, looseness,
improperly adjusted safety devices damage on any components.
– Wipe any dirt off:
o
the window surface to ensure good sight
o
the headlight lenses and the operating light
– Check if all lights are functioning properly, and also if they have the right angles
– Check the the level of:
1. cooling liquid
2. fuel oil
3. engine oil
– Check if the air filter is blocked and if the circuit is damaged.
– Adjust the operator seat to a position suitable for your height and check if the safety
belt/attaching clamp is damaged or worn out.
– Check if the main control lever lies in the central position.
– Adjust all mirrors to obtain the best possible vision of the rear.
– In case of any abnormality, solve it right away to prevent accidental injury or
machine failure later on.
– Keep windows clean and make sure all doors/windows are fixed in a safe
open/closed position.
– Ensure that the horn, motion alarm (if installed) and other warning/safety devices
are set up/working properly.
– Check the undercarriage’s orientation before moving the machine.
NOTE: In normal travel condition, the idler are located at the machine’s front, below the
cabin, while the sprocket should be at the rear.
CAUTION! : In case that the undercarriage is in the opposite position , the travel
control lever must be operated in the opposite direction .