XCMG XE17U, Инструкция по эксплуатации

Страница: 102 / 208

09.2020 Seite 92 / 197
5.3 Travel Operation
Warning! Before operating the travel control, verify the direction the crawlers are
pointing to. If you cannot see the arrows located on the tracks from the
cabin, swing the upper structure half a turn before starting to drive.
Otherwise, you will have to do all the travel control levers’s movements the
opposite of the way you actually want to move the machine.
To start a long-distance travel, swing the upper structure to let the travel
motor at the rear of the canopy.
When traveling down a slope, operate the control pedals slowly.
Before travel, make sure there is nobody on the road and the
excavator. Sound the horn to warn other people that the excavator is
about to move.
During travel, make sure there is nobody on the road and the
excavator. Sound the horn to warn other people that the excavator is
about to move.
When backing up, take extra care to make sure that there are no
obstacles behind.
Be sure to operate the travel control levers smoothly to avoid sudden
start or stop.
Before leaving the seat, be sure to lock all control machines and shut
off the engine to prevent accident
Overview of travel
Notice Follow the steps in the correct order:
1. Set the engine speed control lever to required speed position.
2. Set the safety lever to “unlocked” position.
3. Retract the front equipment until it is lifted about 40-50 cm above the
ground.
4. Ensure that the bucket has been fully retracted.
5. Travel on firm, flat ground as possible and avoid sudden actions and
small-angle cornering.
6. When traveling on irregular ground, select low speed travel mode to
avoid receiving impact load.
7. Take care to avoid excessive stress to the equipment caused by
hooking or stepping on stones.
8. Slow down when traveling on irregular, freezing or rugged ground.