XCMG XE17U, Инструкция по эксплуатации

Страница: 167 / 208

09.2020 Seite 157 / 197
6.11 Maintenance of Engine Cooling System
Caution! – Unless the system has been cooled, don’t loosen the radiator
cap!
– Release the whole pressure before removing the cover, and then
screw it off slowly!
– Protect your eyes and wear the gloves
Coolant Level
Notice!
Coolant Level Check
– Check the level of coolant every day!
– The level of coolant must be between the marks FULL and LOW
on coolant tank. The water tank shall be located behind the
radiator shed door. If the coolant level is below LOW mark, add
the coolant into the water tank. If the water tank is empty, add the
coolant into the water tank after adding the coolant into the
radiator.
Cleaning and Coolant Exchange
Notice! Cleaning
– During the replacement of coolant, clean the inner side of radiator.
– Remove the radiator cap, open the drain cocks of radiator and engine
body to empty the coolant.
– Close the drain cock, add fresh water and radiator cleaner into the
radiator, start the engine and run it at the speed higher than low idle
speed. When the pointer of cooling water thermometer enters into the
green area, continue to run the engine for
over ten minutes.
– Close the engine, open the drain cock, and flush the cooling system with
fresh water until the drained water becomes clean so as to remove the
dirt and deposits.
– Close the drain cock, add the fresh water, and add the antirust agent and
antifreeze agent into the radiator as per the specified mixing ratio. In
order to prevent the air bubble from mixing into the system, add in the
coolant slowly.
– Run the engine to bleed the air of cooling system fully.
– After adding in the coolant, make the engine running for several minutes.
Check the level of coolant again and add in the coolant again according
to the demands.