XCMG XE17U, Инструкция по эксплуатации

Страница: 17 / 208

09.2020 Seite 7 / 197
1.6 Reasonably Foreseeable Misuse
"Reasonably foreseeable misuse" means the use of machinery in a way not prescribed in the instruction
for use, but which may result from readily predictable human behaviors
This includes any undeclared application or type of misuse listed in the Machine Directive (2006/42/EG).
– The machine operator is responsible for all damages done to it due to “unintended use”.
– Any use that is not described in this operating instruction for use is considered as “unintended
use”.
Use of the machine is assumed as reasonable foreseeable misuse in the following cases:
– Operating the machine without/with missing knowledge of the instruction for use
– Operating the machine without the required qualification or operating skills demanded by national
regulations.
– Operating the machine if the instruction for use is missing, incomplete or not available in the
contractually agreed language.
– Operating the machine by persons other than unauthorized operator
– Operating a machine that has not yet been properly tested in accordance with national or
international directives and standards
– Operating the machine with incorrectly applied or malfunctioning safety installations or
equipment. (e.g.: warning signals, emergency stop
– Operating the machine in an unfavorable or hazardous environement according to specifications
in the instruction for use (e.g: explosion hazard due to highly dense dust formation. Be sure to
check the signification of all pictograms attached on facilities or machines in the area).
– Operation of the machine in an unapproved mode.
– Pulling or dragging a load on the ground.
– Expose the machine to physical quantities that exceed the limits prescribed by the manufacturer.
(e.g. ambient temperature,
ASL-altitude,
carried load, wind speed, operating restrictions for
inclined pull, soil slope inclination etc.)
– Install any spare part or interchangeable equipment not approved by the manufacturer
– Any kind of use or structural modification with the machine that endangers operational safety
– Performing repairs or maintenance not prescribed by the manufacturer
– Carrying out any structural modification on the machine or interchangeable equipment which may
affect operational safety without the the manufacturer’s written declaration of approval.
– Bypass or conversion of the required safety installations set in the factory.
– Operating the machine with open cabin door.
– Operating the machine when unauthorized personnel are standing on it or are present in its
immediate vicinity.