XCMG XE17U, Инструкция по эксплуатации

Страница: 18 / 208

09.2020 Seite 8 / 197
– Transport of persons along with the load or with equipment not intended for this purpose.
– Lifting of persons with inadequate equipment or for unintended purposes
– Lifting of other devices on/beneath which persons are located.
– Lifting of loads attached to several lifting devices without considering the load limits defined in the
instruction for use
– In excess of loads or with other components intended for this purpose.
– In excess of tools, rigging equipment or equipment parts (e.g. hammer equipment, piling
equipment or dig)
– Using the machine in special modes not listed in the instruction for use, not approved by the
manufacturer or without required modifications on the machine
– Tilting the machine above the limit angle
– Use of the machine on uneven, undulating, non-compacted, soft ground or ground not capable of
bearing the rise in pressure
– Moving the machine without adequate vision, or without a supervising coworker in case of poor
vision from the cabin
– Use of the machine as tractor (except for machines equipped with a towing attachment or
drawbar eye) under observance of the admissible supported loads, trailing loads or trailer loads.
– Increasing the mass of already lifted loads unnecessarily
– Operating the machine in a different configuration than prescribed by the manufacturer (e.g.
unfitting counterweights, boom components, reeving).
– Lifting of loads in emergency mode
– Lifting loads on the ground with other components/kinematics than the device intended for this
purpose
– Operating the machine below ground (mining).
– Use of the machine for earth-moving work (e.g. leveling).
– Sea travel without observation of the specifications in the instruction for use.
– Installation of interchangeable equipment (e.g. hammer, vibrating drilling or tool) not previously
agreed with the manufacturer.
– Initial start-up of machine.