Specialized Concentrated Focused
「
98
」
Driver
Para.
No.
Function
Value
Description
Pn200
Select pulse
instruction mode
0005
Bit 0: Set 5, select the
instruction input mode as “pulse
+ direction”, negative logic.
Bit 3: Set 0, input differential signal into filter.
Pn50A
Selection function
8100
Bit 1: Set 0, Servo ON /S-ON, input from 40th pin; Set
7, Servo ON all the time.
Bit 3: Set 8, positive rotation not used and signal input
(P-OT) prohibited.
Pn50B
Selection function
6548
Bit 0: Set 8, reverse rotation not used and signal input
(N-OT) prohibited.
Pn50F
Selection function
0300
Set it when servo motor with brakes.
Bit 2: Set 3, brake interlock s
ignal “/BK” is output from
CN1-29, CN1-30 to control 24V relay for brake
Pn50E
Selection function
0211
Set it when servo motor with brakes
To avoid of CN1-29 and CN1-30 being used for other
function and leading to brake ineffective, “3” is not
allowed to appear in the 4 digits.
Pn506
Servo off, time
delay of brake
when motor stops
Depended
Set it when motor with brakes
Default setting is “0”, setting unit is 10ms.
Pn201
Encoder
cycle-divided ratio
(Pulse output No.
per motor cycle by
encoder after
cycle-divided)
Right-side
Gain
Encoder
Type
Encoder Pulse No. per Motor
Circle (pulses/ revolution)
A
13bit 2048
B
16bit 16384
C
17bit 32768
Pn202
Electronic gear
ratio (numerator)
Need
Calculatio
n
Pn202 = pulse No. of each encoder circle × 4 ×
mechanical deceleration ratio.
Pn203 = (lead screw pitch/ pulse equivalent).
Typical value: pitch 5mm, encoder 17-bit, coaxial
connection between motor and screw, pulse equivalent
0.001mm, Pn202
＝
16384; Pn203
＝
625.
Pitch 5mm, encoder 17-bit, coaxial connection
between motor and screw, pulse equivalent 0.0005mm,
Pn202
＝
8192; Pn203
＝
625.
Pn203
Electronic gear
ratio
(denominator)
Need
Calculatio
n
