Specialized Concentrated Focused
「
62
」
Operation
CAUTION
1)
Select an axis first, and only one axis can be selected at one time.
2)
Start Position and End Position should be both within the stroke range, and the latter one should be larger
than the former one.
3)
One Num Run refers to the process from Start Position to End Position and to Start Position again. The laser
interferometer will record a group of data in each Num Run. The screw error compensation file uses their
average value.
4)
Measuring interval = (End Position – Start Position)/ (Num Points -1). If precise measuring is needed, Start
and End Position should be calculated accurately so as to ensure the coordinates of measured points are
integers.
Checking inner circle of circle frame refers to milling the inner area while outer circle for milling the outer
frame. Circle pocket requires setting the X and Y workpiece coordinates. The operation method and
parameter setting principle of round bottom milling, rectangular frame milling and round frame milling are
the same as those of rectangular bottom milling, except for some parameters to be set. Their
corresponding interfaces are shown as below:
Fig. 3-48 Circle Frame