WEG CFW300 V1.3X, Руководство по программированию

Страница: 36 / 157

HMI and Basic Programming
4-2 | CFW300
4
Start-up Mode
„
It is the initial status of the HMI after the successful power-up (without fault,
alarms or undervoltages).
„
Press the key to go to level 1 of the setting mode - parameter selection.
Pressing any other key will also change to the setting mode.
Monitoring
Setting
Level 1
Setting
Level 2
Setting Mode
Level 1:
„
This is the first level of the setting mode. The number of the parameter is shown
on the main display.
„
Use the and keys to find the desired parameter.
„
Press the key to go to level 2 of the setting mode - modification of the
parameter content.
Level 2:
„
The content of the parameter is shown on the main display.
„
Use the and keys to configure the new value for the selected parameter.
„
Press the key to confirm the modification (save the new value). After the
change is confirmed, the HMI returns to level 1 of the setting mode.
Figure 4.3: HMI operating modes
NOTE!
When the inverter is in the fault state, the main display indicates the number of the fault in the format
Fxxx . The browsing is allowed after pressing the key.
NOTE!
When the inverter is in the alarm state, the main display indicates the number of the alarm in the format
Axxx . The browsing is allowed after pressing the key, and then the indication "A" is displayed on
the unit of measurement display, flashing until the situation causing the alarm is solved.