D292144.4.fm
Assembling the TM-500
Chapter 1: Assembly & Installation
1- 7
e.
Replace the bottom bolt on the inside of the enclosure so the enclosure roof is sand-
wiched between the two bolts. Tighten the bolts until the
Tower Light
is secure.
f.
Plug the Tower Light wire
4 Pin Molex Connector
into the matching receptacle inside
the enclosure.
g.
Replace the front wire cover.
5.
Connecting the
Carrier Tape Arm
&
Low Carrier
Tape Sensor
a.
Use an 4 mm hex wrench to connect the
Car-
rier Tape Spindle
to the
Carrier Tape Arm
.
b.
Use an 8 mm hex wrench to connect the
Car-
rier Tape Arm
to the front right corner of the
machine
.
c.
Open the lower front enclosure and locate the
Low Carrier Tape Sensor
wire. Cut the zip tie hold-
ing it in place and thread the wire through the
space between the upper and lower enclosures
near the
Carrier Tape Arm
.
d.
Use an 3/32” hex wrench to connect the
Low
Carrier Sensor
to the
Carrier Tape Arm,
then con-
nect the sensor wire to the sensor. Pivot the sen-
sor in the slot to the desired position. (This will vary
with reel and tape size.)
6.
Connecting the Take-up Arm
a.
Use an 1/4” hex wrench to connect the
Take-
up Arm
.
b.
Plug the power cord into the power recepta-
cle on the front of the machine.
Содержание TM-500
