5-4
TM-500 User’s Guide
Preparing to Run a Pre-programmed Job
D292144.8.fm
Preparing to Run a Pre-programmed Job
The initial set-up and configuration of a new job are covered in
Chapter 4: Machine
Setup
. This chapter covers setup for existing jobs, running a job and routine operator
tasks.
Note:
Admin
or
Super User Level
access is not
necessary for running a job. Go to the
User
Menu
in any of the HMI tabs and select
Log Off
to exit out of
Super User
or
Admin Mode
and pre-
vent job settings from being altered during oper-
ation.
When running a job in
User Mode
, all setting buttons that have been disabled by
the
Super User
are grayed out and the operator only has access to buttons
related to running a job.
Caution:
Users should always wear protective eye wear when operating
or maintaining the TM-500.
Setup Input and Output modules
1.
Ensure the correct
Input
,
Output
and
Test
modules are installed.
2.
Setup the
Dual Tray Feeder
Press the
Center Index
button in the
Tray Tab
to move the
Tray Carriage
to the front of the
machine for loading. Place loaded tray(s) into
input position(s).
• If outputting to Tray 2, place an empty tray in
the output position.
Step 1:
Setup
INPUT
Содержание TM-500
