UTC Fire and Security M3000, Руководство по установке

Страница: 53 / 174

Chapter 4
PXNplus CPU board
43
The following products use these ports: the Integrated Configuration Tool, Picture Perfect, FCWnx/Secure
Perfect, M5PXNplus, M2000PXNplus, M3000PXNplus, and DirecDoor.
Configuring upstream communications with the host
By network
1. Verify that you have a working network. If you need to configure before your network is running, skip
to step 3 .
2. Connect the network cable into J1, the Ethernet connector. See Chapter 9, Regulatory information on
page 143.
3. Use the Integrated Configuration Tool to set the board to network use. The default for this board is
network so you may only need minimal set up. See Chapter 8, Controller firmware tools on page 97.
By network with fallback dial-up
Fallback dial-up is available only using the on-board modem.
1. Install the modem board on the PXNplus CPU board. Refer to the document PXNplus Modem Board
Installation Instructions .
2. Verify that you have a working network. If you need to configure a board before your network is
running, skip to step 3 .
3. Connect the network cable into J1, the Ethernet connector. See Chapter 9, Regulatory information on
page 143.
4. Use the Integrated Configuration Tool to set the board to network use with fallback dial-up. See
Chapter 8, Controller firmware tools on page 97.
By direct-connect
1. Verify that jumper J10 is set to 1 and 2. See Modem control jumper - J10 on page 38.
2. Use the Integrated Configuration Tool to set the board to direct-connect. See Chapter 8, Controller
firmware tools on page 97.
By dial-up
Using on-board modem board
1. Install the modem board on the PXNplus CPU board. Refer to the document PXNplus Modem Board
Installation Instructions .
2. Set Jumper J10 to 2 and 3. See Modem control jumper - J10 on page 38.
3. Use the Integrated Configuration Tool to set the board to dial-up. See Chapter 8, Controller firmware
tools on page 97.