UTC Fire and Security M3000, Руководство по установке

Страница: 100 / 174

M3000
Installation Manual
90
16DO and 16DOR boards
There are two different DO boards available: the 16 Digital Output (16DO) board, and the 16 Digital Output
with Relays (16DOR) board.
The 16DO board provides 16 digital outputs rated at 100 mA @ 24 VDC maximum per output point.
The 16DOR board has 16 relay output points rated at 2 A @ 30 VDC or 0.50 A @ 120 VAC maximum per
output point. The first two relays on each J connector can be wired as Normally Open or Normally Closed. The
last two relays on each J connector are factory-set as Normally Open. Note the following:
• The maximum allowable distance between the M3000 16DO/16DOR board and the output device is
1,000 feet (30.48 m).
• Two-conductor, 22-AWG shielded, stranded wire is recommended for the 16DO board. Two conductor
18 to 22-AWG shielded, stranded wire is recommended for the 16DOR board depending on the cable
distance, amperage (current draw), and voltage of the output device.
• Each DO point is addressed differently depending on the host software you are using.
Device addressing
Picture Perfect
From one to four boards can be configured with DO points from 16 to 31. Picture Perfect addresses DOs by
board number; therefore, the DO numbers are the same for each of the possible four DO/DOR boards.
Facility Commander Wnx and Secure Perfect
From one to four boards can be configured with DO points from 1 to 16. Addressing of DO boards follows the
format:
mmmm-b-pp
where
mmmm
represents the controller number to which this DO is associated,
b
represents the board number, and
pp
represents the point or device number. For example:
0001-1-01 = DO on controller 1, DO board 1, DO 1
0001-2-01 = DO on controller 1, DO board 2, DO 1