UTC Fire and Security M3000, Руководство по установке

Страница: 25 / 174

Chapter 2
Installation planning and mounting
15
Rack mounting
The rack mount enclosure is 19-inch, EIA compatible with the optional rack mount kit.
Mount the controller enclosure using the following steps and Figure 4 on page 16 for reference.
1. Remove the packing material from the enclosure.
2. Use the six #12-24 screws provided to secure the brackets to the enclosure.
3. Secure the enclosure to the rack. This hardware is not supplied; select hardware sized to suit your rack
requirements. Sizes #10-32, #12-24, M5 or M6 screws are common rack mount hardware.
4. Install cable conduit to the M3000 enclosure knockout holes, if required.
The enclosure has knockout holes on the sides, bottom, and back; pull cable through these holes.
To open the holes, strike the knockouts from outside of the enclosure.
5. Fit and tighten approved strain relief clamp in each knockout hole to be used.
6. Find the nearest earth ground (such as, electrical box or ground bus). Run wire from the M3000
enclosure ground terminal (enclosure bottom left) to earth ground point. Use wire size in accordance
with local and national electrical codes. All cables connected to the M3000 must be shielded with the
shield terminated. (See
Figure 2 on page 13.)
CAUTION: Do not apply power to any component during installation. Damage to components may occur.