Tico Pro-Spotter, Руководство по обслуживанию

Страница: 72 / 211

4-4 Service Manual
TICO Manufacturing
ENGINE PRO-SPOTTER
AIR INTAKE SYSTEM
Removal
See Figures 4-3, 4-4, and 4-5.
1. Park and prepare tractor for service. (See “Park
Tractor Safely” on page 1-3.)
2. Raise the cab.
3. Disconnect battery cables. (See “BATTERY” on
page 3-3.)
Figure 4-3: Air Intake System Removal
4. Install identification tags and disconnect electrical
connector (3).
5. Remove filter gauge (1) if necessary.
6. Loosen hose clamps (5) and remove hump hose (4)
and blower-to-hump hose tube (2).
Figure 4-4: Air Intake System Removal
7. Remove nuts (7), washers (8), and saddle clamp (9).
8. Loosen hose clamps (5 and 11) and remove hump
hose (10) and air cleaner-to-hump hose tube (6).
Figure 4-5: Air Intake System Removal
9. Remove cap screws (12), washers (13), and air
intake filter (14).
Inspection
1. Inspect air filter. (See “AIR FILTER” on page 4-5.)
2. Inspect the intake system for cracked silicone hoses,
loose clamps, or punctures, which can allow dirt and
debris to enter the engine.
3. Inspect the air inlet piping including all joints, clamps,
hoses, and connections to ensure they are tight.
4. Verify no holes or tears are present in the system.
5. Inspect air intake pipe supports to ensure no broken
or loose supports exist.
6. Repair or replace parts as necessary.
Installation
Installation is reverse of the removal procedure.
1 Filter Gauge 4 Hump Hose
2 Blower-to-Hump Hose Tube 5 Hose Clamp (3 used)
3 Electrical Connector 6 Air Cleaner-to-Hump Hose
Tube
5 Hose Clamp (3 used) 9 Saddle Clamp
6 Air Cleaner-to-Hump Hose Tube 10 Hump Hose
7 Nut (2 used) 11 Hose Clamp
8 Washer (2 used)
1
TPS-048
2
4
6
3
5
6
TPS-049
6
11
9
7
5
10
8
12 Cap Screw (4 used) 14 Air Intake Filter
13 Washer (4 used)
13
TPS-050
12
14