Tico Pro-Spotter, Руководство по обслуживанию

Страница: 162 / 211

13-8 Service Manual
TICO Manufacturing
CAB PRO-SPOTTER
Removal
See Figures 13-11 and 13-12.
NOTE
Procedure is written for the left side cab latch. Right side
cab latch procedure is similar.
1. Park and prepare tractor for service. (See “Park
Tractor Safely” on page 1-3.)
Figure 13-11: Lock Bar
2. Raise cab completely and allow it to settle into detent
position 1 (full open) (1) of the lock bar (4).
Figure 13-12: Cab Latch (left side shown)
3. Apply alignment marks to bracket and adjuster to aid
when installing.
4. Install identification tags and disconnect hydraulic
lines (5 and 6). Close all openings using caps and
plugs.
5. Remove cap screws (7), washers (8), lock nuts (9),
and cab latch (10).
6. Repair or replace components as necessary.
Inspection
• Clean all parts of dirt and debris.
• Inspect hydraulic lines, fittings, and connections for
leaks, holes, cracks, and loose connections. Replace
parts found to be unserviceable.
• Check all threaded components for damaged or
stripped threads. Repair light damage with thread
chasers. Replace parts found to be unserviceable.
Installation
Installation is the reverse of the removal procedure.
• Check cab air shock alignment with latch. (See
“Adjustment” on page 13-7.)
1 Detent Position 1 (full open) 3 Detent Position 3 (minimum
open)
2 Detent Position 2 (half
open) 4 Lock Bar
TPS-083
1
2
3
4
5 Hydraulic Line 8 Washer (8 used)
6 Hydraulic Line 9 Lock Nut (4 used)
7 Cap Screw (4 used) 10 Cab Latch
5
TPS-149
6
7
8
9
10