Tico Pro-Spotter, Руководство по обслуживанию

Страница: 128 / 211

9-6 Service Manual
TICO Manufacturing
ABS/ATC SYSTEM PRO-SPOTTER
REAR MODULATOR VALVE (IF
EQUIPPED)
Removal
See Figure 9-6.
1. Park and prepare tractor for service. (See “Park
Tractor Safely” on page 1-3.)

CAUTION
2. Release air system pressure. (See “RELIEVING AIR
SYSTEM PRESSURE” on page 8-6.)
Figure 9-6: Rear Modulator Valve (if equipped)
NOTE
Procedure includes servicing of both rear modulator
valves (if equipped) (7). Technicians should only address
the units which are malfunctioning.
3. Install identification tags and disconnect air lines (1
and 2). Close all openings using caps and plugs.
4. Install identification tags and disconnect electrical
connectors (3).
5. Remove cap screws (4), washers (5), lock nuts (6),
and rear modulator valves (if equipped) (7).
6. Repair or replace components as necessary.
Inspection
• Clean all parts of dirt and debris.
• Inspect air lines, fittings, and valves for leaks, holes,
cracks, and loose connections. Replace parts found
to be unserviceable.
• Check all threaded components for damaged or
stripped threads. Repair light damage with thread
chasers. Replace parts found to be unserviceable.
Installation
Installation is the reverse of the removal procedure.
• Test operation of brake system.
• Avoid personal injury from explosion. Air
system components may contain pressurized
gases. Exposure to excessive heat may
cause components to explode.
• Avoid personal injury from high-pressure
gases or debris. High-pressure release of
gases or debris from a pressurized system
can cause penetrating injuries. Relieve
system pressure from air system before
servicing.
1 Air Line (2 used) 3 Electrical Connector (2
used) 5 Washer (8 used) 7 Rear Modulator Valve (2
used) (if equipped)
2 Air Line (2 used) 4 Cap Screw (4 used) 6 Lock Nut (4 used)
7
TPS-112
7
1
1
2
2
4
5
6
5
6
4
3
3