Tico Pro-Spotter, Руководство по обслуживанию

Страница: 118 / 211

8-4 Service Manual
TICO Manufacturing
AIR SYSTEM PRO-SPOTTER
Inspection
• Clean all parts of dirt and debris.
• Inspect air lines, fittings, and valves for leaks, holes,
cracks, and loose connections. Replace parts found
to be unserviceable.
• Check all threaded components for damaged or
stripped threads. Repair light damage with thread
chasers. Replace parts found to be unserviceable.
Installation
Installation is the reverse of the removal procedure.
AIR SYSTEM SCHEMATIC
Air system schematics are used to aid in servicing and
troubleshooting pneumatic equipment. These schematics
my differ greatly depending on the optional equipment
installed. To view the most accurate applicable system
schematic, contact TICO support. (See “CONTACT TICO
SUPPORT” on page 0-15.)
AIR TANK
Removal
See Figures 8-2, 8-3, 8-4, and 8-5.
NOTE
Procedure is written for the left side air tank. Right side
air tank procedure is similar.
1. Park and prepare tractor for service. (See “Park
Tractor Safely” on page 1-3.)
2. Remove rear grate. (See “GRATES AND COVERS”
on page 14-5.)

CAUTION
3. Release air system pressure. (See “RELIEVING AIR
SYSTEM PRESSURE” on page 8-6.)
Figure 8-2: Air Release Cables and Clamp
4. Remove cap screw (1), washers (2), and lock nut (3).
5. Remove air release cables (4 and 5) from clamp (6)
and set aside.
Figure 8-3: Air Tank (rear view)
• Avoid personal injury from explosion. Air
system components may contain pressurized
gases. Exposure to excessive heat may
cause components to explode.
• Avoid personal injury from high-pressure
gases or debris. High-pressure release of
gases or debris from a pressurized system
can cause penetrating injuries. Relieve
system pressure from air system before
servicing.
1 Cap Screw 4 Air Release Cable
2 Washer (2 used) 5 Air Release Cable
3 Lock Nut 6 Clamp
7 Air Line 10 Lock Nut (2 used)
8 Air Line 11 Cap Screw (2 used)
9 Washer (4 used) 12 Air Tank
2
TPS-094
1
3
4
5
6
2
7
TPS-095
8
9
10
11
12