Tico Pro-Spotter, Руководство по обслуживанию

Страница: 167 / 211

PRO-SPOTTER CAB
TICO Manufacturing
Service Manual 13-13
CAB TILT PUMP
Removal
See Figure 13-21.
1. Park and prepare tractor for service. (See “Park
Tractor Safely” on page 1-3.)
2. Lower cab completely and allow it to settle into full
resting position.
3. Remove cab tilt pump cover. (See “LEFT COVERS
AND GUARDS” on page 14-8.)
Figure 13-21: Cab Tilt Pump
4. Install identification tags and disconnect electrical
connectors (1 and 2).
5. Install identification tags and disconnect hydraulic
line (3). Close all openings using caps and plugs.
6. Remove cap screws (4), washers (5), and cab tilt
pump (6).
7. Repair or replace components as necessary.
Inspection
• Clean all parts of dirt and debris.
• Inspect hydraulic lines, fittings, and connections for
leaks, holes, cracks, and loose connections. Replace
parts found to be unserviceable.
• Check all threaded components for damaged or
stripped threads. Repair light damage with thread
chasers. Replace parts found to be unserviceable.
• Inspect electrical connectors and wiring for damage,
corrosion, or loose connections. Replace parts found
to be unserviceable.
Installation
Installation is the reverse of the removal procedure.
CHECK FLUID LEVEL
Cab Tilt Hydraulic Fluid
See Figure 13-22.
1. Park and prepare tractor for service. (See “Park
Tractor Safely” on page 1-3.)
2. Lower cab completely and allow it to settle into full
resting position.
Figure 13-22: Cab Tilt Reservoir
3. Compare actual fluid level (4) to applied level mark
(2) on the cab tilt reservoir (1).
4. If necessary, add oil to fill reservoir. (See “Cab Tilt
Hydraulic Fluid Filling” on page 13-12.)
1 Electrical Connector 4 Cap Screw (2 used)
2 Electrical Connector 5 Washer (2 used)
3 Cab Tilt Pump-to-Cab Tilt
Cylinder Hydraulic Line 6 Cab Tilt Pump
1
TPS-146
4
5
3
2
6
1 Cab Tilt Reservoir 3 Reservoir Cap
2 Applied Level Mark 4 Actual Fluid Level
1
TPS-145
2
3
4