Tico Pro-Spotter, Руководство по обслуживанию

Страница: 101 / 211

PRO-SPOTTER FRONT AXLE & STEERING
TICO Manufacturing
Service Manual 6-9
8. Subtract the lowest reading from the highest reading.
This number represents the axial play or total
distance between pushing and pulling.
9. Compare calculated axial play to specification. If
calculated play is outside of the specification, adjust
the wheel bearings.
.0.001-0.005
10. If calculated play is within the specification, the wheel
bearings are properly adjusted. No additional
adjustments are required.
Figure 6-11: Wheel Bearing Adjustment
11. Remove the counter nut (5), lock washer (6), and
lock ring (7).
IMPORTANT
Prevent possible damage to components. Do not
strike the adjustment nut (8) with a metal hammer. Do
not use a chisel or punch to loosen the adjustment
nut. This may cause damage to the nut.
12. Tighten the adjustment nut (8) to specification while
turning the tire in both directions.
.
13. Loosen the adjustment nut completely.
14. Tighten the adjustment nut to specification while
turning the tire in both directions.
.
15. Turn the adjustment nut counterclockwise 1/3 turn.
16. Install the counter nut (5), lock washer (6), and lock
ring (7). Tighten counter nut to specification.
17. Install the gasket (4), hub cover (3), washers (2), and
cap screws (1). Tighten cap screws to specification.
18. Lower vehicle to the ground.
19. Check vehicle operation.
Specifications
Axial Play—Distance
0.03—0.13 mm
0.001—0.005 in
1 Cap Screw (6 used) 6 Lock Washer
2 Washer (6 used) 7 Lock Ring
3 Cover Hub 8 Adjustment Nut
4 Gasket 11 Hub
5 Counter Nut
Specifications
Adjustment Nut—Torque
136 N·m
100 lb·ft
1
TPS-175
2
3
4
5
6
7
8
11
Specifications
Adjustment Nut—Torque
136 N·m
100 lb·ft
Specifications
Counter Nut 28.6—66.7 mm
(1-1/8 to 2-5/8 in,
approximate)—Torque
271—407 N·m
200—300 lb·ft
Counter Nut 66.7 mm and
larger (2-5/8 in and larger,
approximate)—Torque
339—407 N·m
250—400 lb·ft
Specifications
Cap Screw—Torque
27—41 N·m
20—30 lb·ft