Tico Pro-Spotter, Руководство по обслуживанию

Страница: 87 / 211

PRO-SPOTTER TRANSMISSION
TICO Manufacturing
Service Manual 5-3
11. Perform a hot manual check once the transmission
fluid has reached 71°—93°C (160°—200°F).
For additional service and maintenance information, see
the Allison Transmission® operator’s manual.
Manual Check—Hot
See Figures 5-3 and 5-4.
The hot check band (3) on the dipstick (1) offers the best
assurance of maintaining the correct fluid levels. Hot
checks should be performed at normal transmission
operating fluid temperatures of 71°—93°C (160°—
200°F). While a cold check must be performed prior to
start-up, fluid levels for continued operation should be
adjusted based on hot check results.
1. Ensure transmission fluid has reached a normal
operating fluid temperature of 71°—93°C (160°—
200°F).
2. Park the tractor on a level surface and shift to neutral
(N).
3. Apply the parking brake.
Figure 5-3: Dipstick Location
4. Clean any dirt or debris from the end of the fill tube
before removing the dipstick (1).
5. Remove the dipstick and wipe it clean.
NOTE
Manual transmission fluid level checks should be
performed with the dipstick in the unscrewed or loose
position.
6. Insert the dipstick into the fill tube. Push down until
the dipstick stops while still in an unscrewed or loose
position.
Figure 5-4: Manual Hot Check
7. Remove the dipstick and observe the fluid level. If the
transmission fluid is within the hot check band (3),
the fluid level is satisfactory.
8. If necessary, add or remove transmission fluid until
the transmission fluid level is within the hot check
band.
9. Perform a hot manual check once again to ensure
consistent measurements.
For additional service and maintenance information, see
the Allison Transmission® operator’s manual.
Electronic Check—Hot
See Figure 5-5.
The electronic hot check offers additional information not
available when performing a manual check. The
transmission gear selector (4) will delay displaying the
fluid level results until the following conditions are met:
• The transmission fluid temperature is above 40°C
(104°F) or below 104°C (220°F).
• Transmission is in neutral (N).
• The tractor has been stationary for approximately 2
minutes to allow the fluid to settle.
• The engine is running at idle.
While an electronic check provides more specific
information regarding the fluid level, a manual check
should be performed to verify the electronic check
results.
1. Park the tractor on a level surface and shift to neutral
(N).
2. Apply the parking brake.
NOTE
The tractor must be completely stopped with a
transmission output shaft speed of 0 rpm.
3. Allow the engine to idle.
4. Allow the transmission fluid to settle for 2 minutes.
1 Dipstick
TPS-071
1
1 Dipstick 3 Hot Check Band
HOT ADD
HOT
FULL
CO
L
D
ADD
C
OL
D
FULL
1
TPS-070
3