Heavy-Duty Sack truck witH Pu tyreS
300kg caPacity
Model no:
cSt990HD
thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. Safety
9
Always load evenly with the centre of gravity of the load as near the centre and
rear of the plate as possible.
9
obtain additional support for large or wide loads to prevent tipping.
8
Do not
overload the truck - see Specification.
8
Do not
leave unattended, especially when loaded, unless the wheels are
chocked or the truck is otherwise secured.
8
Do not
use truck on uneven ground and do not run over curbs or steps - use a
ramp.
8
Do not
allow others to ride on the truck.
8
Do not
use the truck if any part is damaged, paying particular attention to the
wheels.
2. introDuction
Heavy-duty tubular steel construction with welded joints with 300kg capacity. Puncture proof
heavy-duty PU tyres with powder coated steel hubs. Features foldaway toe plate for added
extension when transporting larger loads. Three year warranty.
3. SPecification
Model no: ............................................................CST990Hd
Capacity: ...................................................................... 300kg
Height(s): ................................................................. 1220mm
nett Weight: ................................................................ 14.6kg
overall Width: ............................................................ 580mm
Platform depth: .......................................................... 300mm
Wheel Bore Size: ...................................................... Ø20mm
Wheel Size: ............................................................. Ø250mm
Wheel Width:................................................................ 85mm
4. aSSeMbly
4.1.
Wheels. ensure each axle is clean from dust and dirt to allow free movement of
the wheel. You will need to slide the axle through the frame bushes first.
4.2.
Slide the wheel (fig.2.2) onto the axle (fig.2.1), followed by the washer (fig.2.3)
and complete by pushing the split pin (fig.2.4) through the hole in the end of the
axle and bending over to retain.
4.3.
Repeat for the other side.
fig.1
fig.2
CST990Hd Issue 1 16/05/19
Original Language Version
© Jack Sealey limited
Refer to
instructions
Wear safety
footwear
