Thermo Scientific Dionex AS-DV, Руководство оператора

Страница: 104 / 132

Dionex AS-DV Operator’s Manual
94
Doc. 065259-05 10/12
a. Install a fitting and ferrule onto one end of the line that will
connect the Dionex AS-DV valve to the injection valve. If you
are creating this line, use tubing appropriate for your IC system.
b. Connect the line to the appropriate port on the Dionex AS-DV
valve:
For a 6-port valve, connect the line to port
4 .
For a 10-port valve, connect the line to port
6
.
c. Connect the other end of the line to the sample inlet port on the
injection valve in the IC system. Use a fitting and ferrule
appropriate for your IC system.
4. To complete the 6-port valve plumbing for injection valve operation,
refer to Figure B-5 and to the manual for the IC system.
5. Replace the front cover and close the top cover on the Dionex AS-
DV.
Go on to Section B.4 .
B.4 Connecting the Drain Line
1. Locate the corrugated drain hose (P/N 055075) in the Dionex AS-DV Ship
Kit.
2. Push the hose onto the
DRAIN
port on the
Dionex AS-DV rear panel. Make sure the
hose is pushed securely onto the port.
3. Place the free end of the hose into a waste
container or appropriate drain.
4. Make sure that the outlet of the drain line
is below the level of the Dionex AS-DV
and is not elevated at any point.