Thermo Scientific 48i, Инструкция по эксплуатации

Страница: 156 / 321

Troubleshooting
Troubleshooting Guides
6-2 Model 48 i Instruction Manual Thermo Fisher Scientific
Table 6–2 lists all the alarm messages you may see on the graphics display
and provides recommendations about how to resolve the alarm condition.
Table 6–1. Troubleshooting - General Guide
Malfunction Possible Cause Action
Does not start (the light on
display does not come on
and the pump motor is not
running) No power or wrong power
configuration Check the line to confirm
that power is available and
that it matches the voltage
and frequency configuration
of the instrument.
Main fuse is blown or
missing Unplug the power cord, open
the fuse drawer on the back
panel, and check the fuses
visually or with a multimeter.
Bad switch or wiring
connection Unplug the power cord,
disconnect the switch and
check operation with a
multimeter.
Pressure transducer does not
hold calibration or is noisy Pressure transducer
defective Replace pressure transducer.
Run output noisy Recorder noise Replace or repair recorder.
Sample CO concentration
varying Run instrument on a span CO
source - if quiet, there is no
malfunction.
Foreign material in optical
bench Clean optical bench.
Analyzer does not calibrate
properly System leak Find and repair leak.
Pressure or temperature
transducer out of calibration Recalibrate pressure and
temperature transducer.
Dirty system Clean cells and flow
components.
Leaky correlation wheel Replace with a known good
wheel.
Analog test ramp Faulty recorder Replace recorder.
D/A calibration off Re-calibrate the D/A with a
DMV known to be in
calibration.