Tektronix 6 series, Печатная инструкция

Страница: 53 / 518

Connect TPP0500B, TPP1000, , TekVPI, or other supported Tektronix analog probes by pushing them into a
FlexChannel connector. The probe base latch locks with a 'click' when the probe is fully seated.
TekVPI probes automatically set the channel input parameters for that probe (bandwidth, attenuation, termination, and so on). If
a probe has a Menu button, push that button to open an on-screen configuration menu. Follow instructions provided with active
probes to set their parameters (auto zero, degauss, and so on).
To connect a TLP058 FlexChannel Logic Probe or a TDP7700 Series TriMode
™
Probe:
1. Move the locking lever to the unlocked position, then let go to reset locking lever to the center position.
2. Insert the probe into a FlexChannel connector until fully seated and the lock mechanism clicks.
3. Move the locking lever to the locked position. The status light should be a solid green.
4. To disconnect the TLP058 probe, move and hold the locking lever at the unlocked position and pull out the probe. Do not
pull on the ribbon cable while removing the probe.
Connect a BNC probe or cable by pushing it onto a channel BNC bayonet connector and turn the lock mechanism clockwise until
it locks.
NOTE. Connecting a probe does not automatically enable that channel (make it active). Use the instrument controls or
programmatic interface to turn on a channel and open its configuration menu to verify or change probe or cable settings
(bandwidth, attenuation, termination and so on).
Rackmount information
The optional RM5 Rackmount Kit lets you install the oscilloscope in standard equipment racks. The rack mount requires seven
rack units (7U) of space to install. The MSO58LP ships with attached rack mount hardware to install into a 2U rack space.
Contact Tektronix Customer Support to purchase the rackmount kit option RM5. Follow the instructions that come with the
rackmount kit (RM5 Rackmount Kit Instructions, Tektronix part number 071-3523-xx).
Make sure to allow at least two inches of clearance on the sides for air ventilation, and on the back for any cables you attach to
the rear panel.
The MSO58LP comes equipped with rack mount hardware installed so that you can immediately add it to a rack. Follow the
instructions in the 5 Series MSO MSO58LP Installation and Safety Manual to install the instrument in a rack.
To use an MSO58LP on a bench, purchase and install the 5 Series MSO MSO58LP Benchtop Conversion kit (Tektronix part
number 020-3180-xx). The kit includes chassis feet and a handle, and lets you stack instruments on a bench.
Install your instrument
MSO54, MSO56, MSO58, MSO58LP, MSO64 Help 33