D 13373.08
NOVEMBER 2007
MPS
TANDBERG
MPS
ADMINISTRATOR GUIDE
Restart the TANDBERG MPS
To activate changes to the Parameter Configuration
the MPS requires a restart.
Use
•
Arrow Left
to step back to the main menu and
select
Restart
Parameter Configuration
Initial Configuration
LCD
Before using the TANDBERG MPS it requires
some basic configuration. This is done
through the Liquid Crystal Display (LCD) on
the front of the chassis.
Preparing the MPS
Follow the instructions in the
section to prepare the
system for configuration.
Static Network Addresses
Follow the instructions, to the right, to con-
figure static network addresses and Ethernet
speed of the System Controller Board (SC)
and the Media Processing Board.
Access to the MPS
After configuring the IP-address of the System
Controller Board (and restart the MPS), you
may continue the configuration from the web
interface. You have access to the TANDBERG
MPS by entering the IP-address of the System
Controller Board in a standard Web-browser.
Enter Password
You will be asked to enter a password. The
Internet Explorer 7 requires a User Name to
be entered. Could be such as ‘admin’. The
default password for the TANDBERG MPS is
“TANDBERG”. The password is case sensitive.
Change Password
To change the password of the system, you
need to log into the Command Line Interface.
For information please see the TANDBERG
MPS API document supplied with the system
or on
!
LCD buttons
Press
Arrow Up
to move up in the menu or to increase a digit (0 –> 9)
Press
Arrow Down
to move down in the menu or to decrease a digit (9 –> 0)
Press
Arrow Left
to step back in the menu or to move the next digit to the left
Press
Arrow Right
to step forward in the menu or to move the next digit to the right
Press
Confirm
button to confirm a selection
Press any key to open the main menu.
•
Use
•
Arrow
buttons to select from the sub-
menu and press the
Confirm
button.
Use
Arrow
buttons to select
Media IP Config
and press the
Confirm
button.
Use
Arrow
buttons to select a line and set the
three addresses and the Ethernet speed. Use
Arrow Left
to step back in the menu.
IP
: Defines the static IP address of
the Media Processing Board: Example
<
192.168.001.200
>
SNM
: Defines the static IP Subnet Mask for
the network: Example <
255.255.255.000
>
GW
: Defines the static IP Gateway address:
Example <
192.168.001.001
>
IF Speed
: Defines the Ethernet speed: <
Auto/
10Half/10Full/100Half/100Full
>
Media IP Config
- Configuration of the Media
Processing Board (MPS 200 having 1-2 boards
and MPS 800 having 1-8 boards).
If more than one Media board the menu will be
extended with the number of boards installed.
Use Arrow buttons to select the desired board
and continue the configuration.
Parameter Config
- Configuration of System
Controller Board(s) and Media Processing
Board(s).
Parameter Info
- See the configuration of
the System Controller Board(s) and Media
Processing Board(s).
LCD Settings
- Configuration of the LCD.
Restart
- Restart the MPS
Parameter Config
Parameter Info
LCD Settings
Restart
SC IP Config
Media IP Config
IP <
192.168.001.200
>
SNM <
255.255.255.000
>
GW <
192.168.001.001
>
IF Speed <
100Full
>
Media 1 IP Config
Media 2 IP Config
Initial Configuration
Media Processing Board - Parameter Configuration
29
Introduction
Quick
Setup
Using
the MPS
System
Status
System
Configuration
Gateway
Configuration
MCU
Configuration
Technical
Descriptions
Appendices
Main
Installation
