Tabor Electronics 5251, Руководство пользователя

Страница: 221 / 298

4
Remote Programming Reference
Error Messages
4-87
waveform, or activating the built-in sine waveform when one of
the 5251 filters is turned on. Corrective action: If in sine, select
another function and activate the filter(s).
4. Activating burst mode when the 5251 is set to sequence mode,
or activating sequence mode when the 5251 is set to burst
mode. Corrective action: Remove the 5251 from burst or
sequence and then selected the desired mode.
5. Changing operating mode from triggered to continuous when the
5251 is set to single sequence advance, or changing the
operating mode from continuous to triggered when the 5251 is
set to automatic sequence advance mode. Corrective action:
Observe the 5251 advance mode while setting sequence
advance.
-222,”Data out of range”. Parameter data, which followed a specific
header, could not be used because its value is outside the valid
range defined by the generator.
-224,”Illegal parameter value”. A discrete parameter was received
which was not a valid choice for the command. An invalid
parameter choice may have been used.
-300,”Device-specific-error”. This is the generic device-dependent
error for the instrument when it cannot detect more specific errors.
A device- specific error as defined in IEEE-488.2 has occurred.
-311,”Memory error”. Indicates that an error was detected in the
instrument’s memory.
-350,”Queue Overflow”. The error queue is full because more than
30 errors have occurred. No additional errors are stored until the
errors from the queue are removed. The error queue is cleared
when power has been shut off, or after a *CLS command has been
executed.
-410,”Query INTERRUPTED”. A command was received which
sends data to the output buffer, but the output buffer contained data
from a previous command (the previous data is not overwritten).
The output buffer is cleared when power is shut off or after a device
clear has been executed.