Tabor Electronics 5251, Руководство пользователя

Страница: 215 / 298

4
Remote Programming Reference
Auxiliary Commands
4-81
Half Cycle
Programming
Use the following command for programming the half cycle
functions and their associated parameters. There are three half
cycle functions: Sine, Triangle and Square. The specifications and
limitations of the half cycle functions are specified in Appendix A.
AUXiliary:HALFcycle:DELay<delay>(?)
Description
This command will program the interval of which the output idles between half cycles. The idle level is
normally 0 V except if programmed otherwise with the volt:offs command.
Parameters
Name Range Type Default Description
<delay> 200e-9 to 20 Numeric 1e-6 Will set the delay time interval between half cycles in
units of seconds.
Response
The 5251 will return the half cycle delay value in units of seconds.
AUXiliary:HALFcycle:DCYCle<duty_cycle>(?)
Description
This command will program the duty cycle of the square waveform when the half cycle square shape is
selected. Note that this command has no effect on the standard square wave duty cycle.
Parameters
Name Range Type Default Description
<duty_cycle> 0 to 99.99 Numeric 50 Will set the delay time interval between half cycles in
units of seconds.
Response
The 5251 will return the square wave duty cycle value in units of percent.
AUXiliary:HALFcycle:FREQuency<freq>(?)
Description
This command programs the frequency of the half cycle waveforms in units of hertz (Hz). It has no affect on
the frequency of other waveform functions.
Parameters