Tabor Electronics 5064, Руководство пользователя

Страница: 302 / 369

E
r
r
o
r
!
B
o
o
k
m
a
r
k
n
o
t
5-81
-128."Numeric data not allowed". A legal numeric data element was
received, but the instrument does not accept one in this position.
-131,"Invalid suffix". A suffix was incorrectly specified for a numeric
parameter. The suffix may have been misspelled.
-148,"Character data not allowed". A character data element was
encountered where prohibited by the instrument.
-200,"Execution error". This is the generic syntax error for the
instrument when it cannot detect more specific errors. Execution
error as defined in IEEE-488.2 has occurred.
-221,"Setting conflict". Two conflicting parameters were received
which cannot be executed without generating an error. Listed below
are events causing setting conflicts.
1. Sum of pulse or ramp parameters is more than 100. Corrective
action: Change parameters to correct the problem.
2. ampl/2 + |offset| is more than 16. Corrective action: Reduce
offset to 0, then change amplitude-offset values to correct the
problem.
3. Activating filters when the 2074 is set to output the built-in sine
waveform, or activating the built-in sine waveform when one of
the 2074 filters is turned on. Corrective action: If in sine, select
another function and activate the filter(s).
4. Activating burst mode when the 2074 is set to sequence mode,
or activating sequence mode when the 2074 is set to burst
mode. Corrective action: Remove the 2074 from burst or
sequence and then selected the desired mode.
5. Changing operating mode from triggered to continuous when the
2074 is set to single sequence advance, or changing the
operating mode from continuous to triggered when the 2074 is
set to automatic sequence advance mode. Corrective action:
Observe the 2074 advance mode while setting sequence
advance.
-
222,”Data out of range”. Parameter data, which followed a specific
header, could not be used because its value is outside the valid
range defined by the generator.
-
224,”Illegal parameter value”. A discrete parameter was received
which was not a valid choice for the command. An invalid
parameter choice may have been used.
-
300,”Device-specific-error”. This is the generic device-dependent
error for the instrument when it cannot detect more specific errors.
A device- specific error as defined in IEEE-488.2 has occurred.
-
311,”Memory error”. Indicates that an error was detected in the
instrument’s memory.
-
350,”Queue Overflow”. The error queue is full because more than