Tabor Electronics 5064, Руководство пользователя

Страница: 138 / 369

3
Using the Instrument
Using the Half Cycle Waveforms
3-67
The next step is to tell the master instrument that will become slave
instrument. Remember that the 2074 can synchronize more than
two instruments and that each one must be connected to a LAN
network for communications and synchronization signals and
therefore, all instruments must be set up to operate from a LAN
interface and each instrument must have a unique LAN address for
identification.
Slave units are identified by their LAN address. Press the Slaves IP
Address soft key button to access the identification menu as shown
in Figure 3-43.
There are two additional soft key commands added as you enter
the Slaves IP Address menu: Insert Slave and Delete Slave. Use
these buttons to add or remove salve identifications from your
synchronization list. Every IP address that will be added to this table
will automatically become part of the synchronization scheme.
Figure 3-43, Programming Slaves IP Address
The final step to synchronize all instruments is the Couple State
button as shown in figure 3-44. Select the Active state and press
Enter to synchronize the instruments.