Tabor Electronics 5064, Руководство пользователя

Страница: 274 / 369

E
r
r
o
r
!
B
o
o
k
m
a
r
k
n
o
t
5-53
Run Mode
Commands
The Run Mode Commands group is used to synchronize device
actions with external events. These commands control the trigger
modes of the Model 2074. The generator can be placed in
Triggered, Gated or Burst mode. Trigger source is selectable from
an external source, an internal re-trigger generator or a software
trigger. Optional nodes were omitted from these commands. The
Run Mode settings affect all waveform shapes equally except when
using the modulated waveforms. In the case of modulated
waveform, the output idles on the carrier waveform until stimulated
to output a modulation cycle or burst of cycles. Additional
information on the run mode options and how the 2074 behaves in
the various run mode options is given in Chapter 3. Factory defaults
after *RST are shown in bold typeface. Parameter low and high
limits are given where applicable
.
Table
‎
5-7, Run Mode Commands
Keyword Parameter Form Default
:INITiate
[:IMMediately]
:CONTinuous OFF | ON | 0 | 1 1
:TRIGger
[:IMMediate]
:BURSt
[:STATe] OFF | ON | 0 | 1 0
:COUNt 1 to 1000000 1
:DELay
[:STATe] OFF | ON | 0 | 1 0
:TIMe 200e-9 to 20 200e-9
:GATE
[:STATe] OFF | ON | 0 | 1 0
:LEVel -5 to 5 1.6
:SOURce
[:ADVance] BUS | EXTernal | MIXed EXT
:SLOPe POSitive | NEGative POS
:RETRigger
[:STATe] OFF | ON | 0 | 1 0
:TIMe 200e-9 to 20 200e-9
INITiate:CONTinuous{OFF|ON|0|1}(?)
Description
This command will set the output in continuous operation and interrupted operation. The run mode
commands will affect the 2074 only after it will be set to interrupted operation.