Suzuki WagonR+ RB310, Руководство по обслуживанию

Страница: 986 / 3086

AUTOMATIC TRANSAXLE (M13 ENGINE MODEL) 7B1-21
2) Connect scan tool to data link connector (DLC) (1).
Special tool
(A): SUZUKI scan tool
3) Turn ignition switch ON.
4) Read DTC, pending DTC and freeze frame data according to
instructions displayed on scan tool and print it down. Refer to
scan tool operator
’ s manual for further details.
5) After completing the check, turn ignition switch OFF and dis-
connect scan tool from data link connector (DLC) (1).
Diagnostic Trouble Code (DTC) Clearance
After repair or replace malfunction part(s), clear all DTCs by per-
forming the following procedure.
1) Connect SUZUKI scan tool to data link connector in the
same manner as when making this connection for DTC
check.
2) Turn ignition switch ON.
3) Erase DTC and pending DTC according to instructions dis-
played on scan tool. Refer to scan tool operator ’ s manual for
further details.
4) After completing the clearance, turn ignition switch off and
disconnect scan tool from data link connector.
NOTE:
If SUZUKI scan tool cannot communicate TCM, perform
“ Serial Data Circuit Check ” described in this section.
1
(A)
WARNING:
When performing a driving test, select a safe place where
there is neither any traffic nor any traffic accident possi-
bility and be very careful during testing to avoid occur-
rence of an accident.
NOTE:
DTC and freeze frame data stored in TCM memory are
also cleared in following cases. Be careful not to clear
them before keeping their record.
• When power to TCM is cut off (by disconnecting bat-
tery cable, removing fuse or disconnecting TCM con-
nectors).
• When the same malfunction (DTC) is not detected
again during 40 engine warm-up cycles.