Suzuki WagonR+ RB310, Руководство по обслуживанию

Страница: 2945 / 3086

8G-10 IMMOBILIZER CONTROL SYSTEM
SCAN TOOL DATA
As the data value given below are standard values estimated on the basis of values obtained from the normally
operating vehicles by using a scan tool, use them as reference values. Even when the vehicle is in good condition,
there may be cases where the checked value does not fall within each specified data range. Therefore, judgment
as abnormal should not be made by checking with there data alone.
Also, conditions in the table below that can be checked by the scan tool are those detected by immobilizer control
module and output from immobilizer control module as commands.
SCAN TOOL DATA VEHICLE CONDITION
NORMAL CONDITION/
REFERENCE VALUES
IGNITION SW Ignition switch turned to ON position ON
TRANSPONDER Ignition switch turned to ON position DETECTED
TRANS SKC Ignition switch turned to ON position REGISTERED
FIX CODE Ignition switch turned to ON position REGISTERED
NUMBER OF FC (Vehicle is in normal condition) 1-5 pcs
PASSWORD (Vehicle is in normal condition) PROGRAMMED
WAIT LOOP (Vehicle is in normal condition) INACTIVE
WAIT TIME (Vehicle is in normal condition) 0 SEC
SCAN TOOL DATA DEFINITIONS
IGNITION SW
Ignition key switch position
ON: Ignition switch at ON position
OFF: Ignition switch at OFF position
TRANSPONDER
DETECTED: Transponder in ignition key is detected by immobilizer control module.
NOT DETECTED: Transponder in ignition key is not detected.
TRANS SKC
REGISTERED: Secret key is registered in ignition key with built-in transponder.
NOT REGISTERED: Secret key is not registered in ignition key with built-in transponder yet.
FIX CODE
REGISTERED: The FIX CODE of ignition key which is inserted in key cylinder is registered in immobilizer control
module.
NOT REGISTERED: The FIX CODE of ignition key which is inserted in key cylinder is not registered in immobilizer
control module.
NUMBER OF FC (PCS)
The number of registered ignition key (FIX CODE).
PASSWORD
REGISTERED: Password is registered in immobilizer control module.
NOT REGISTERED: Password is not registered. It is necessary to register password to set immobilizer control
module in normal operation status.
WAIT-LOOP
INACTIVE: Security system is inactive. It is ready for password input on scan tool.
ACTIVE: Incorrect password was inputted and system is in wait-loop status. Inputting password is inhibited for the
waiting time described below.
WAIT TIME (SEC, MIN)
The time it must be waited for reinput password for programming SUZUKI scan tool indicates “ 0 SEC. ” when a
correct password is input after wait time.
If failed to input correct password, it increase according to the times of misinput.