Suzuki WagonR+ RB310, Руководство по обслуживанию

Страница: 2719 / 3086

1. E-ring
2. Washer
3. Reverse select spring
4. Blank
5. Gear shift interlock plate
6. Ball
7. Gear shift interlock
spring
8. Gear shift & select lever
9. Spring pin
10. Spring pin
11. Ball
12. Gear shift & select shaft
13. 5th & reverse gear shift
cam
14. Spring pin
15. Cam guide return spring
16. 5th & reverse gear shift
cam guide
17. Spring pin
18. Low speed select spring
7A-28 MANUAL TRANSMISSION
GEAR SHIFTER
GEAR SHIFT AND SELECT SHAFT ASSEMBLY
1) To disassemble component parts, use special tools and 2.8 – 3.0
mm (0.11 in.) pin remover in addition.
Special Tool
(A): 09922-85811(4.5 mm)
(B): 09925-78210 (6.0 mm)
2) Clean all parts thoroughly, inspect them and replace with new
ones as required.
3) Assemble component parts by reversing removal procedure.
NOTE:
!
When driving in spring pins, prevent shaft from being
bent by supporting it with wood block.
!
Assemble 5th & reverse gear shift cam by winding cam
guide return spring, and then drive in spring pin.
!
Distinguish low speed spring (No paint) (18) from reverse
select spring (Pink) (3).
HIGH SPEED AND LOW SPEED GEAR SHIFT SHAFTS
INSPECTION
1) Using feeler gauge, check clearance between fork (1) and
sleeve (2) and replace those parts if it exceeds limit below.
NOTE:
For correct judgement of parts replacement, carefully in-
spect contact portion of fork and sleeve.
Clearance “ a ” : Service limit 1.0 mm (0.039 in.)
2) Insert each gear shift shaft into case and check that it moves
smoothly. If it doesn ’ t, correct by using oilstone, reamer or the
like.