Suzuki WagonR+ RB310, Руководство по обслуживанию

Страница: 3041 / 3086

10B-24 AIR BAG SYSTEM
Q02 connector
DTC 18: PASSENGER AIR BAG INITIATOR CIRCUIT SHORT TO GROUND
STEP ACTION YES NO
1 Was item “ AIR BAG SYSTEM CHECK
FLOW TABLE ” described in this section
performed?
Go to step 2. Perform “ AIR BAG
SYSTEM CHECK FLOW
TABLE
” in this section.
2 1) With ignition switch OFF, disconnect
passenger air bag (inflator) module
connector behind the glove box.
2) Check proper connection to passenger
air bag (inflator) module at terminals in
Q02 connector.
3) If OK then connect Special Tool (B) to
Q02 connector instead of passenger
air bag (inflator) module. (See figure
below.)
With ignition switch ON, is DTC 18 current?
Go to step 3. 1) Ignition switch OFF.
2) Replace passenger
air bag (inflator)
module.
3 1) With ignition switch OFF, disconnect
Special Tool (B) and SDM connector.
2) Check continuity between Q06-23 and
Q06-31 terminals. (See figure below.)
Is there continuity?
Repair short from “ Y ” or
“ Y/R ” wire circuit to
ground.
Substitute a known-good
SDM and recheck.
Fig. for STEP 2 Fig. for STEP 3
Special Tool
(A): 09932-76010
(B): 09932-75010
NOTE:
Upon completion of inspection and repair work, perform following items.
1) Reconnect all air bag system components, ensure all components are properly mounted.
2) Clear diagnostic trouble codes (Refer to
“ Diagnostic Trouble Code (DTC) Clearance ” ), if any.
3) Repeat “ Air Bag Diagnostic System Check ” in this section to confirm that the trouble has been cor-
rected.