Suzuki WagonR+ RB310, Руководство по обслуживанию

Страница: 2564 / 3086

“ a ”
1
2
3
ENGINE COOLING 6B-7
7) Remove reservoir (1) and remove cap (2) from reservoir and
pour out any fluid, scrub and clean inside of tank with soap and
water.
Flush it well with clean water and drain. Reinstall reservoir.
8) Disconnect coolant hose from throttle body for improving air
purging efficiency and add 50/50 mixture of good quality ethyl-
ene glycol antifreeze and water to radiator until coolant over-
flow disconnected hose. And connect coolant hose to throttle
body.
Fill radiator to the base of radiator filler neck and reservoir to
“ FULL ” level mark (3). Reinstall reservoir cap and align match
marks (4) on reservoir and cap.
9) Run engine, with radiator cap removed, until radiator upper
hose is hot.
10) With engine idling, add coolant to radiator until level reaches
the bottom of filler neck. Install radiator cap, making sure that
the ear of cap lines is parallel to radiator.
WATER PUMP BELT TENSION
WARNING:
Disconnect negative cable at battery before checking and
adjusting belt tension.
1) Inspect belt for cracks, cuts, deformation, wear and cleanliness.
If it is necessary to replace belt, refer to WATER PUMP BELT in
this section.
2) Check belt for tension. Belt is in proper tension when it deflects
8 to 10 mm (0.32 – 0.39 in.) under thumb pressure (about 10 kg
or 22 lbs (1).).
Belt tension “ a ” : 8 – 10 mm (0.32 – 0.39 in.) as deflection
NOTE:
When replacing belt with a new one, adjust belt tension to
6
– 7 mm (0.24 – 0.27 in.).
3) If belt is too tight or too loose, adjust it to proper tension by dis-
placing generator position.
4) Tighten belt adjusting bolt (2) and generator pivot bolt (3).
5) Connect negative cable at battery terminal.