Stanley 00496014, Инструкция по эксплуатации и обслуживанию

Страница: 8 / 300

3. INTENT OF USE
The hydro-pneumatic 74200 tool is designed to place Stanley Engineered Fastening Blind Rivet Nuts at high speed making it
ideal for batch or flow-line assembly in a wide variety of applications throughout all industries.
A complete tool is made up of the base tool (part number 74200-12000) and the appropriate nose assembly for the
insert, as described on page 10.
NOSE ASSEMBLIES MUST BE FITTED AS DESCRIBED ON PAGE 10.
DO NOT use under wet conditions or in the presence of flammable liquids or gases.
4. PUTTING INTO SERVICE
IMPORTANT - READ THE SAFETY RULES ON PAGE 4 - 6 CAREFULLY BEFORE PUTTING INTO
SERVICE.
Select relevant size nose equipment and install.
Connect the placing tool to the air supply. Test pull and return cycles by depressing and releasing the trigger 25. Set the tool
for desired stroke/pressure.
CAUTION - Correct supply pressure is important for proper function of the installation tool. Personal injury or
damage to equipment may occur without correct pressures. The supply pressure must not exceed that listed in
the placing tool specification.
4.1 AIR SUPPLY
All tools are operated with compressed air at an optimum pressure of 5.5 bar. We recommend the use of pressure regulators
and automatic oiling/filtering systems on the main air supply. These should be fitted within 3 metres of the tool (see diagram
below) to ensure maximum tool life and minimum tool maintenance.
Air supply hoses should have a minimum working effective pressure rating of 150% of the maximum pressure produced
in the system or 10 bar, whichever is the highest. Air hoses should be oil resistant, have an abrasion resistant exterior and
should be armoured where operating conditions may result in hoses being damaged. All air hoses MUST have a minimum
bore diameter of 6.4 millimetres or 1/4 inch.
Read servicing daily details page 13.
14
2
114
2
8
TAKE OFF POINT FROM MAIN SUPPLY
(USED DURING MAINTENANCE OF
FILTER/REGULATOR OR LUBRICATION
UNITS)
MAIN SUPPLY
DRAIN POINT
3 METRES
MAXIMUM
STOP CLOCK
LUBRICATOR
Fig. 2
8
ENGLISH ORIGINAL INSTRUC TION