
PCM-D10
51
Sony CONFIDENTIAL
For Authorized Servicer
SECTION 3
TEST MODE
Note 1:
The information which are not opened to customers are
included in the following procedure. After you are cautious
of handling of information, execute work under the suf-
fi
cient administration.
When the leakage has been revealed by any chance, the
source of information is speci
fi
ed.
Note 2:
There is a step of executing “Factory Shipment” in the test
mode item. Executing “Factory Shipment” will initialize
the built-in memory
fi
les and settings. Backup the built-in
memory
fi
les to a PC or SD card beforehand.
Beforehand preparation:
• Open the battery lid on the rear side of main unit, install the four
size AA batteries.
Note
3:
Use the following batteries so that the batteries will not run out
during work.
New alkaline battery
or
Fully charged Ni-MH battery
• Refer to “BACKUP OF THE BUILT-IN MEMORY FILES” on
page 5, be sure to backup the
fi
les have been recorded in the
built-in memory beforehand.
1. SETTING THE TEST MODE
Setting method:
1. Turn the power on by turning ON of the [POWER] switch on the
left side of main unit.
2. Turn the stopped state by pressing the [
x
STOP] on the front
side of main unit.
[
x
STOP] button
3. Operate each button in the following order.
1
Turn on the [HOLD] switch.
2
Press the [T-MARK] button.
3
Press the [T-MARK] button.
4
Press the [ A-B
V
] button.
5
Press the [VOL
−
] button.
6
Press the [
v
DPC] button.
7
Press the [
v
DPC] button.
8
Press the [OPTION] button.
9
Press the [OPTION] button.
q;
Press the [
.
] button.
qa
Press the [
.
] button.
1
23
[T-MARK] button
5
[VOL –] button
67
[
v
DPC] button
q;qa
[
.
] button
89
[OPTION] button
4
[ A-B
V
] button
4. After the screen is disappeared, the screen is displayed again, the
and the test mode menu is displayed.
Note:
If the screen is disappeared and is not displayed, remove the batteries,
and install them again, operate from step 1.
Version
Contrast Setting
LCD LED Light
Sleep
OFF DeepSleep
Power Down
Key Count
HotPlug Count
Log
Screen turned off
Test mode menu
5. Turn off the [HOLD] switch with state displayed the test mode
menu.
2. RELEASING THE TEST MODE
Select the “Factory Shipment” from the test mode menu and execute
it.
After the “Factory Shipment” is completed, test mode state is re-
leased, this unit reboots automatically, and it boots in the normal
mode.
(Refer to “4-12. Factory Shipment” on page 55)
SYS SET
2019/03/08 01:38:10 (GMT+09:00)