Working Instruction
,
Mechanical
3/00021-1/FEA 209 544/594 B
©
Sony Ericsson Mobile Communications AB
81(128)
4.23.2
Installation of Cable Assemblies
If this part is being replaced, a new part should be used in the place of the old part when the
following steps are being performed.
Tools needed:
•
Torque screwdriver
•
JCIS No. 0 bit
•
Style 2A ESD tweezers (Blunt tip)
Step-by-Step Instructions
NOTE! If this procedure is only being performed to
replace the cable assemblies, skip to the
note following step 3. If the hinge and/or
the hinge sleeve are being replaced, obtain
the new parts that are needed and proceed.
1.
If the hinge sleeve is being replaced but the hinge
assembly is not, remove the old hinge sleeve from
that hinge assembly at is time.
2.
If there is not a hinge sleeve on the hinge, place a
hinge sleeve over the “doughnut” shaped portion of
the hinge as shown.
NOTE! Be careful not to damage the cable
assemblies when inserting them through the
center hole in the hinge assembly.
NOTE! The end of the cable assemblies that has the
bundling feature furthest from the
connectors is the end of the cable assemblies
that should be passed through the hinge.
3.
Obtain a new set of cables and do not separate the
two cables or remove the plastic sleeves that hold the
ends of the two cables together.
4.
From the side of the hinge in which hinge sleeve is
mounted, carefully slide the sleeved end of the set of
cables that have the bundling features furthest from
the connectors through the center hole of the hinge
assembly.
5.
Remove the plastic sleeves that hold the cable
assemblies together.
