Working Instruction
,
Mechanical
3/00021-1/FEA 209 544/594 B
©
Sony Ericsson Mobile Communications AB
13(128)
2.2
Base Reassembly
The reassembly of the base portion of this product is broken down into sections by the
components that need to be installed to perform the reassembly of the base portion. The sections
that make up the “Base Reassembly” procedure are arranged in the order that they must be
performed to properly reassemble the base portion of this product. If only a partial disassembly
of the base has been performed, perform the only necessary reassembly sections.
2.2.1
Circuit Board Installation
Tools needed:
•
Pry Tool
•
Style 2A ESD tweezers (Blunt tip)
Step-by-Step Instructions
1.
Obtain the outer base cover and orient it so that its
inner surface is towards you.
2.
Verify that the antenna assembly, the rear speaker
assembly, and the vibrator are in their correct
positions.
3.
Verify that the antenna contact is correctly mounted
on top of the rib that protrudes up from the inner
surface of the outer base cover.
NOTE! There are two alignment pegs that position
the contact portion of the antenna. Make
sure that the two alignment pegs protrude
through their corresponding holes in the
contact portion of the antenna.
4.
Remove the side speaker from its cavity that is along
the inner wall of the outer base cover by prying the
end of the speaker nearest the system connector
opening up out of the outer base cover. Then lift the
speaker from its cavity using your fingers.
