Working Instruction
,
Mechanical
3/00021-1/FEA 209 544/594 B
©
Sony Ericsson Mobile Communications AB
18(128)
Step-by-Step Instructions
3.
Select the cable you are going to connect and orient
the connector end of the cable so that the side of the
connector with the two notches is oriented away
from the board.
NOTE! Be careful not to damage the cable
assemblies when reconnecting them to the
circuit board.
NOTE! Do NOT attempt to plug the cable
assemblies in by using the cable assembly
itself to push the cable connection into the
board connection. Damage to the cable
assembly most likely will result.
4.
Place the end of the cable assembly into the opening
of its board connection.
5.
Using the tip of a pair of style 2A tweezers, work the
end of the cable into its board connector. There are
two locations that the connection on the end of the
cable must be alternately pushed at to get the cable
connection completely seated into its board
connector. The pushing locations are labelled
location 1 and location 2.
6.
Repeat the previous three steps to connect the other
cable/board connection.
7.
Once the cables are connected to the circuit board,
insert each of the cables into their corresponding
cable holders on the circuit board.
