Working Instruction
,
Mechanical
3/00021-1/FEA 209 544/594 B
©
Sony Ericsson Mobile Communications AB
35(128)
Step-by-Step Instructions
9.
Verify that the power key, the camera key, the
volume key, and the music player key are correctly
positioned after the display carrier has been installed.
NOTE! When the display carrier and the inner flip
cover are correctly mated, the four screw
holes in the two components should be
aligned.
10.
Obtain the hinge/cable assembly.
NOTE! The cable with the color mark connects to
the display flex film connection that
is not
adjacent to the microphone.
11.
Select the cable you are going to connect and orient
the connector end of the cable so that the side of the
connector with the two notches is oriented away
from the flex film.
NOTE! Do NOT attempt to plug the cable
assemblies in by using their mass of wires to
push the cable connections together.
Damage to the cable assemblies are likely to
result.
12.
Position the end of the cable assembly adjacent to its
corresponding connection slot on the flex film so
that all the connection needs is to be pressed
together.
NOTE! Be careful not to damage the cable
assemblies when connecting them to the
display flex film.
13.
Using the tip of a pair of style 2A tweezers, work the
end of the cable into its connector. There are two
locations that the connection on the end of the cable
must be alternately pushed to get the cable
connection completely seated into its connector. The
pushing locations are labeled location 1 and location
2.
14.
Repeat the previous three steps to connect the other
cable to the display flex film.
