Working Instruction
,
Mechanical
3/00021-1/FEA 209 544/594 B
©
Sony Ericsson Mobile Communications AB
4(128)
1
General
1.1
Phone Portions - Base and Flip
This document uses the hinge of the phone to divide the phone into two identifiable portions.
The portion of the phone that contains the keypad will be referred to throughout this document as
the base portion of the phone. The other portion of the phone is the part that contains the display.
This will be referred to as the flip portion of the phone. The basic disassembly and reassembly
procedures will be structured based on these two distinct portions.
1.2
Using Hand and ESD Protection
When handling this product, keep all surfaces clean of dirt, dust, debris, and hand oil. Use
appropriate ESD precautions when working on this product. The use of finger cots or gloves, an
ESD mat, and an ESD wrist strap are required at minimum.
1.3
Protection of LCDs, Lenses, and Windows
Any time the screen portion of a display assembly, the windows of a display cover, or a camera
lens is unprotected and will be exposed for an extended period of time, add a protective film over
the exposed part to reduce the amount of dust, finger prints, debris, and/or damage that the part
may obtain.
1.4
Acceptable Pry Tools
Whenever the phrase “pry tool” is used, a nylon pointer, an orangewood stick, or a front opening
tool may be used, depending on the user’s preference.
1.5
When an “ * ” appears beside a Tool in “Tools Needed:”
A “ * ” beside a tool in a procedure’s list of tools indicates that the tool is not specifically called
out in those instructions, but an operator may find it helpful to use that tool when performing
some steps of that procedure.
