SISTEM AIR Industrial Clean Basic, Техническое руководство

Страница: 112 / 384

Industrial Clean instruction manual
34
15/02/12 Rev:1.0.0
11 USE OF THE APPLIANCE
Once the Industrial Clean dust separator, has been connected to the power supply, it can be started every
time a fl exible hose is plugged into any of the suction sockets installed in the different rooms.
The vacuum cleaning is started thanks to an electrical contact assembled directly in the socket which, once
activated, allows the start of the suction motor of the vacuum cleaning unit.
The specifi cally-designed electronics applied to Industrial clean dust separators is based on a sophisticated
software designed exclusively for Sistem Air, which alerts the operator, by means of a dedicated messaging
package, when routine maintenance should be carried out.
Such maintenance involves the dust bin to be emptied and the fi lter cartridge to be regularly cleaned.
Any time the computer shows an alarm notice, the fl exible hose must be removed and plugged in in
order to start suction again.
11.1 Switching the machine on
11.2 Using the machine
Position the main switch assembled on the
right side on the appliance on «I-ON» posi-
tion. The display will switch on to indicate the
unit is connected to the power supply.
Fix the cleaning accessory most suitable for the
desired task to the grip handle of the fl exible hose.
Select the accessories according to the required
use, to the type of dirt and area to be cleaned, etc.
1
1
Insert the other end of the fl exible hose in the
suction socket on the wall. This will switch on
the system suction motors by activating the
electric signal in the suction socket.
Once you have carried out the cleaning operations, remove the fl exible hose from the suction
socket by gently accompanying the closing fl ap until it reaches its housing. If the fl ap is left to
close by itself, it will violently hit the suction socket because the suction system is still working
and the vacuum will pull the fl ap powerfully against the suction frame.
The unit is programmed to take a few seconds before switching off to ensure that the suction
action has been completed throughout the piping network.
2
0
1