4-25
Section 4
Special Printing
Using the Liner
Printing on the back side may require a liner to be used depending
on the media type. Also, use a liner when printing on the back side
if printing of dark density was performed on the face side.
- Confirm the vertical scale in advance because the vertical
scale is different if the liner is used.
- The liner wrinkles easily, and therefore if the liner is wound
on the winder, it is recommended that only the liner be wound,
not the printed media.
The following explanation assumes that the printing on the face
side has been completed.
1
Insert a liner roll into the sub scroller.
Confirm the take-up direction of media, and
insert the sub scroller into the liner roll.
2
Lock the flange on the left side.
Insert the left flange into the shaft, and rotate
the knob clockwise to lock the left flange.
Sub scroller
The flange on the right side is secured to the
sub scroller. When setting the sub scroller in
the printer, this side comes to the right.
Left flange
(In case of outer take-up)
NOTE
Double-Sided Printing
