3-38
(25) Priority setting (HEATER)
Selects the priority of heater temperature setting.
<Parameter (Enter a value)>
- DATA:
Gives priority to data.
- PANEL:
Gives priority to the panel.
(26) Selecting the media width detection method
Sets the media width detection method.
Set the media width manually when media of which width cannot
be detected by the edge sensor is used.
<Parameter (Enter a choice)>
- AUTO:
Detects the media width automatically using the
edge sensor.
- MANUAL 1: The printer works using the value set to the SIZE
parameter as the media width.
- MANUAL 2: The printer works using the value set to the SIZE
parameter as the media width.
-
Select MANUAL 1 if a liner size is different from the me-
dia width when a liner is set during the print on mesh
media.
-
Select MANUAL 2 if a media such as clear film that can-
not be detected by the edge sensor is used.
-
This setting is validated when media is set. If this setting
is changed, the media must be set again.
#PRIORITY HEATER
>01 : DATA
# DETECT WIDTH
AUTO
HINT
