2-60
The area from the paper discharge
sensor position to the print start
position (the grid roller) becomes a
dead area.
The dead area can be decreased by
r e w i n d i n g t h e m e d i a f o r t h e
d i s t a n c e b e t w e e n t h e p a p e r
discharge sensor and the grid roller.
(20 to 30 mm from the front edge
cannot be printed.)
NOTE
-
Cut the edge of the media so that it will be parallel to the
guide line before installing the media.
If the edge of the media is not parallel to the guide line, the
print area at the top is cut, the platen is stained with ink,
and a media jam may be caused.
6
Input the base point (print offset value for media width
direction: origin point).
7
Select “*Yes” or “No” for feed back operation.
BASE POINT
✽
0000 mm
The origin moves if either the media width or base point is set.
Print margin
Base point input value
Media width input value
PAPER FEED BACK
✽
NO
PAPER FEED BACK
✽
YES
Normally the previously set base
point is displayed.
Image
data
