4-6
1
Set the media.
For the installation of media, see
page 2-12 to 2-20 "Installing/
Removing the Media."
At this time, select "FACE" with the
or
key on the opera-
tion panel for "
Media Position
."
- If a tarpaulin (surface condition is different between face and
back) intended for single side printing is used, first print on
the more uneven surface side as the face side.
- For printing on thick tarpaulin (0.5 mm or thicker), the head
height must be raised. (
⇒
See page 2-66)
2
Set media to the take-up unit.
For setting the media to the winding unit, see
pages 2-27 to 2-33
"Installing the Media Roll in the Winder."
Also, the back side print requires a margin exceeding about 2.5m,
so wind the media on the winder by about 4 turns in advance.
3
Start the printing on the face side.
4
After the printing is finished, cut the media.
When the printing on the face side is completed, two more lines are
printed. The first line is a solid line for aligning the print position
between the face and back; the second line is a broken line for a
cutting guideline.
Cut the media on the paper feed side, leaving the two lines.
-
Marking the first solid line for aligning the print position
on both edges of the back side will be convenient when
setting the back side.
MEDIA POSITION
SELECT: FACE
HINT
NOTES
