Sanken Samco SVC06, Инструкция по эксплуатации, Страница: 9 / 136

- 7 -
C
h
ap
ter
1
1
–5 Notes on Wiring
1-5 Notes on wiring
Danger

Wiring must be performed by qualified personnel.
Failure to observe this warning may result in an electric shock or fire due to incorrect wiring.

Do not connect AC power to an output terminal (U, V, or W).
Failure to observe this warning may result in personal injury or fire.

Do not use if rated voltage is exceeded.
Failure to observe this warning may result in personal injury or fire.

Do not connect a resistor directly to the DC terminals (P and X).
Failure to observe this warning may result in a fire.

Connection between the ground terminals must be reliable.
Failure to observe this warning may result in electric shock if ungrounded.
For the thickness of grounding wires, please refer to the wire sizes specified in the instruction manual.

Please tighten the terminal block screws according to specified tightening torques.
Failure to observe this warning may result in a fire.

Check that the AC power supply voltage is equal to the rated voltage of the inverter.
Failure to observe this warning may result in personal injury or fire.

For cable types and diameters, please use the cables specified in the instruction manual.
Failure to observe this warning may result in heating or a fire if the diameters of wires are too small.

Secure the inverter before wiring.
Failure to observe this warning may result in electric shock or personal injury.
Caution

The inverter, motor or wiring may cause interference. Please note misoperation of peripheral
devices.
Failure to observe this warning may result in accidents.

If a Residual Current-operated protective Device (RCD) is to be used, it must be an RCD type B.

If the input and output are terminal blocks, the wire heads must be connected with crimp
terminals.
Failure to observe this warning may result in electric shock or fire.